Prime logotipo Exclusivo para miembros Prime: ¿Nuevo en Audible? Obtén 2 audiolibros gratis con tu prueba.
Elige 1 audiolibro al mes de nuestra inigualable colección.
Escucha todo lo que quieras de entre miles de audiolibros, Originals y podcasts incluidos.
Accede a ofertas y descuentos exclusivos.
Premium Plus se renueva automáticamente por $14.95 al mes después de 30 días. Cancela en cualquier momento.
How to Use a 3D Printer  Por  arte de portada

How to Use a 3D Printer

De: HowExpert Press, Zachary Hestand
Narrado por: Zachary Hestand
Prueba por $0.00

US$14.95 al mes después de 30 días. Cancela en cualquier momento.

Compra ahora por US$15.49

Compra ahora por US$15.49

la tarjeta con terminación
Al confirmar tu compra, aceptas las Condiciones de Uso de Audible y el Aviso de Privacidad de Amazon. Impuestos a cobrar según aplique.

Resumen del Editor

If you want to learn how to use a 3d printer, then listen to this short, step by step guide.

You will learn everything you need to learn about 3d printing in a fun and concise way.

©2016 HowExpert.com (P)2016 HowExpert.com

Lo que los oyentes dicen sobre How to Use a 3D Printer

Calificaciones medias de los clientes
Total
  • 3.5 out of 5 stars
  • 5 estrellas
    1
  • 4 estrellas
    1
  • 3 estrellas
    1
  • 2 estrellas
    1
  • 1 estrella
    0
Ejecución
  • 3.5 out of 5 stars
  • 5 estrellas
    2
  • 4 estrellas
    0
  • 3 estrellas
    1
  • 2 estrellas
    0
  • 1 estrella
    1
Historia
  • 3 out of 5 stars
  • 5 estrellas
    1
  • 4 estrellas
    1
  • 3 estrellas
    1
  • 2 estrellas
    0
  • 1 estrella
    1

Reseñas - Selecciona las pestañas a continuación para cambiar el origen de las reseñas.

Ordenar por:
Filtrar por:
  • Total
    2 out of 5 stars
  • Ejecución
    1 out of 5 stars
  • Historia
    1 out of 5 stars

the narrator was obviously 13 years old

the narrator was obviously using words that he has either never used before or is not old enough to have used them a lot. He gets stuck on words that are pretty fundamental to what he's talking about, and leaves you thinking that he probably should have practice saying the script before recording the audio book. The book is only 30 minutes long or so but he spends a third of that talking about how to unbox your 3D printer. honestly, you can skip this whole book entirely and learn more on Google in just a couple minutes.
the book is written and narrated by the same 13 years old person, which is fine, but also sort of shows that he didn't have enough people proof read this before publishing it. if it wasn't such a hassle to get money back on purchase books, this would be one of those ones I'd get my money back on. don't bother wasting your $2.50 on this book.

Se ha producido un error. Vuelve a intentarlo dentro de unos minutos.

Has calificado esta reseña.

Reportaste esta reseña